The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Saw Armor Carry Tray for Makita DC18RD and 6 x 18V LXT battery holders installed (DC18RD charger and batteries are not included)

$159.99
(No reviews yet) Write a Review
SKU:
SA-CT-DC18RD-6SM
Weight:
4.00 LBS
Shipping:
Free Shipping

Product includes:

1 x formed aluminum carry tray with pre drilled holes for mounting a Makita DC18RD battery charger and 6 x Makita 18V LXT battery holders permanently installed with rivets.

4 x T20 x 40mm mounting screws for the DC18RD (see installation instructions below).

Installation:

Tools required for installation:

1 x #2 Phillips head screw driver

1 x Torx T20 driver

1. Remove the carry tray from packing box.

2. Remove the rubber feet from your DC18RD - they just pop out.

3. Use a Phillips screwdriver to remove the screws inside the feet holes.

4. Place the DC18RD onto the carry tray and align the holes.

5. Install the provided screws with a Torx T20 driver from underneath the tray.

Instructions:

The carry tray can be hung on the two mounting holes and carried by the handle.

The battery brackets are only compatible with Makita 18V LXT batteries.

To install a battery, simply snap it into a bracket by sliding the battery into the bracket from the top.

Ensure that The battery is fully seated into the bracket and that you hear a "click" as the battery snaps into place.

To remove the battery, depress the white button on the battery while pulling the battery up.

Batteries must be correctly installed into the brackets prior to moving or carrying the tray.

If the battery is not fully locked into the mount, it may fall out and cause injury.

Electrical Safety Warning:

Ensure that the 110V cord is routed through the opening on the right hand lower side of the tray.

Do not allow the battery charger cord to come into contact with any metal edges of the tray. This may damage the insulation on the 110V cord and cause a short.

If the 110V battery charger cord becomes frayed or damaged, unplug it from the power outlet and stop using it immediately.

Remove the charger from the tray and contact a Makita Service Center to repair your charger cord.

  • 1-800-4 MAKITA
  • (1-800-462-5482)

Hours: Monday through Friday 8am - 6pm (EST)

Dimensions: 2" x 12" x 20"

Weight: 4 Lbs